The program a suitable name like your callsign followed by code plug. Scan list after clicking "Scan list" on the menu will result in the Scan List and an "Add" tab will appear so click on that also. More than the one Scan list, "right click" the mouse whilst pointing at List may be set up by clicking on "Scan List in the side menu. Anything that was not highlighted with a red arrow is best left alone! Click on a channel in the list as in the case of channel 2Ĭlick the add button in the centre of theīox and the channel will be added to the zone as in the case of Channel1ġ6 zones may be programmed with channel members. This Zone canīe renamed by back spacing over the Zone 1 name and giving a relevantĬhannels to the Zone, available channels will be listed in the left handĬolumn. On Zone 1 in the menu and the screen shown will appear. "Add" will appear click on that and it will add a Zone into the list.ĭo it several times and there will be a few more Zones added. "right clicking" the mouse on the Zone information, a small tab with This equates to a total of 256 channelsThis allows one to sort their channels Repeater it is essential to program the TX and RX frequency to suit thatĪre a maximum of 16 Zones selectable on the average Hand Held Radio. It is planned to use the Hand Held Radio with a hotspot or Local Tones can be added if the Analog mode is selected. The method is the same as for Digital Channels. Is possible to program in Analogue channels by selecting Analog in theĬhannel mode. Power - Set to Low power if using a Hotspot but, set to High power if going through a TOT (s) - Set to 180s for network operation. Repeater Slot - Can only be set to 1 or 2 - in our case we set this to 2
#DMR PROGRAMMING ID FREE#
#DMR PROGRAMMING ID SOFTWARE#
↳ Datamodes, SDR & other Radio Software.All I can find is the contact list and call alias I've got the talk group info for GB7NS from the repeater group site but I just can't see where I'd enter that in to the Hytera programing software, I entered it into the contact list but it doesn't look right to me.
I don't know if it would be under a different name but I'm just totally lost with the Hytera software. Hi thanks for the info I've watched your video and I can kinda make sense of it but putting that info into the Hytera 705 LT CPS I just can not find the talk group list or what it would be under. It's not exactly the same programming software but it should be very similar. If you don't understand DMR programming at all then go on YouTube and search for my video titled tyt md380 programming for amateurs. The name you call it doesn't make any difference to the radio side of things. You need to actually find all the talkgroups/groups (same meaning) online that are used on the repeater. Just looked at the screenshot you posted more carefully.